1/2X4X96FSB Bucket Pin This bucket ear boss is

This bucket ear boss is machined to accept a 50mm bucket pin

A bucket pin shim will work just fine if it is a little larger than the Outer Diameter of your pin but not if it is smaller (it has to fit around the pin)

You will also need a 35-40lk lock

2 pads are used on each stabilizer arm

1/2X4X96FSB Bucket Pin This bucket ear boss is1 2" x 4" x 96" Flat single bevel, weld on cutting edge. Good to weld under the front edge of your bucket to give it a wear surface or to replace the front lip of your bucket. If it becomes the new front lip of your bucket you can drill or blow holes in it to match a bolt on edge if you like.